• RE programming keyless entry
  • Started by roushzx2
  • roushzx2
  • Master ZX2ner
  • *****

    • 921


    • 0
    • February 25, 2010, 08:40:45 PM
    • scranton,pa
  • more
RE programming keyless entry
on: December 17, 2006, 11:00:52 PM
« Last Edit: December 31, 1969, 04:00:00 PM by Guest »
1. Turn the ignition switch from OFF to ON eight times within ten seconds, ending with ON, or turn the ignition switch from OFF to START four times within 10 seconds, ending with ON.

2. Note: If the RAP module successfully entered the program mode, it will lock and then unlock all doors. (For Mexican anti-theft system, it will chirp the horn.)

Press any button on the keyless entry remote transmitter.

3. Note: The door locks will lock and then unlock to acknowledge that the keyless entry remote transmitter has successfully been programmed. (For Mexican anti-theft system, it will chirp the horn.)

To program additional transmitters, repeat step 2.

4. Note: The door locks will lock and then unlock one last time to indicate the new keyless entry remote transmitters have been programmed and the program mode has been exited. (For Mexican anti-theft system, it will chirp the horn one last time.)


  • pauly
  • Junior Member
  • **

    • 86


    • 0
    • August 09, 2008, 05:01:37 PM
    • Dartmouth, Nova Scotia
  • more
Re: RE programming keyless entry
Reply #1 on: December 18, 2006, 05:35:00 PM
« Last Edit: December 31, 1969, 04:00:00 PM by Guest »
Funny.  I was just wondering how to do this the other day.  Thanks!!! 8-)
Pauly

First
On
Race
Day!


Re: RE programming keyless entry
Reply #2 on: December 19, 2006, 06:11:42 AM
« Last Edit: December 31, 1969, 04:00:00 PM by Guest »
I was tooo. My keyless entrees been out for awhile since I changed out from a horribly dead battery. Nice writ up and Ill go try it out now.
99 ZX2 mods: Otto Racing Strut bar, MAC Performance (zxtuner) UDP, Pacesetter muffler, EGT rear sway bar, zxtuner black box mod, Zxtuner CAI, MSD coil pack, MSD 8.5mm spark plug wires, knocker mod


Re: RE programming keyless entry
Reply #3 on: December 19, 2006, 07:14:29 AM
« Last Edit: December 31, 1969, 04:00:00 PM by Guest »
I think my car needed 8 turns of the ignition....

Mac


  • roushzx2
  • Master ZX2ner
  • *****

    • 921


    • 0
    • February 25, 2010, 08:40:45 PM
    • scranton,pa
  • more
Re: RE programming keyless entry
Reply #4 on: December 19, 2006, 10:06:09 AM
« Last Edit: December 31, 1969, 04:00:00 PM by Guest »
You might have done something wrong the 1st time thus 8 times instead of 4


Re: RE programming keyless entry
Reply #5 on: December 19, 2006, 02:52:05 PM
« Last Edit: December 31, 1969, 04:00:00 PM by Guest »
I very well may have,,,,
I played with it for a while to get it to program... :-D

Mac