My eq ~

Now that is sweet.  Can you provide some more information about what you have done there?

To install , you must remove the cubby and tuck away the cigerette lighter ,measure and cut the appropiate size square with a Dremel and wire into a relay that you attach onto the cd/radio lead  or use the radios turn on lead .

  In my case I use a 20amp relay to turn on my eq , 3 way electronic crossover and my 3 amplifiers .

The inside of the cubby hole isn't uniform.  It is a little lower on one side, did you need to change anything to compensate?

The eq that I used is a single din size. When you do the measurements and fit it , it wont matter , there is nothing behind it except the ecu , which is way below it .

By that I think he means that he cut off the actual cubby.  He's only using the front surface and the snaps to hold it in place.  Everything else has been removed.

I could be wrong, but that's what it sounds like to me.  Looks good though!

- Darron