• Removing stock stereo faceplate
  • Started by Mike Smith
Removing stock stereo faceplate
on: January 23, 2010, 04:15:10 AM
« Last Edit: December 31, 1969, 04:00:00 PM by Guest »
Any trick to this? My daughter's '98 has a cassette deck that won't hold the cassette in (she wants to use a cassette adapter for her iPod). I think if I can get the radio out, I can probably fix the little microswitch that I assume is the problem, but I'd like get any tips on how to get the face plate off before I dive into it.

Thanks!
\'00 Subaru 2.5 RS (my daily driver/auto-x weapon)
\'02 Subaru Forester L auto (wife\'s car)
\'00 Chevy S-10 5sp 4cyl p/u (for haulin\' stuff)
\'98 ZX2 auto (daughter\'s car)


  • zonker
  • Member
  • ***

    • 221


    • 0
    • July 05, 2010, 04:22:06 AM
    • Temecula, CA
  • more
Re: Removing stock stereo faceplate
Reply #1 on: January 23, 2010, 11:45:45 AM
« Last Edit: December 31, 1969, 04:00:00 PM by Guest »
easy if you do it in the right order...

1. turn the heater temp knob to full cold and disconnect the heater control cable at the hvac box under the dash above the accelerator pedal. its a tab you bend a little as you pull it off the rod sticking out of the hvac box.

2. slide in the radio removal tools in the pinhole openings at each side of the faceplate and pull it back.

3. disconnect the electrical switch wiring harness (large white plug to the right of the stereo case), then the antenna and 2 plugs on the back of the stereo and you should have the whole ball of radio in your hands.

hope that helps...

rob
http://http://www.zxtuner.com
1999 ZX2 S/R (stock and back on the road!)
1999 ZX2 S/R (Performance Parts project car) - Ticket magnet
1998 ZX2 Base (MPG project car) - 38.6 mpg  - SOLD
2000 ZX2 A/T (daughters car) - not totalled yet lol


Re: Removing stock stereo faceplate
Reply #2 on: January 24, 2010, 02:50:31 AM
« Last Edit: December 31, 1969, 04:00:00 PM by Guest »
"radio removal tools"? There's special; tools required? :?
\'00 Subaru 2.5 RS (my daily driver/auto-x weapon)
\'02 Subaru Forester L auto (wife\'s car)
\'00 Chevy S-10 5sp 4cyl p/u (for haulin\' stuff)
\'98 ZX2 auto (daughter\'s car)


  • zonker
  • Member
  • ***

    • 221


    • 0
    • July 05, 2010, 04:22:06 AM
    • Temecula, CA
  • more
Re: Removing stock stereo faceplate
Reply #3 on: January 24, 2010, 06:35:08 PM
« Last Edit: December 31, 1969, 04:00:00 PM by Guest »
ford radio removal tools - they're available all over the place for like 5-10 bucks. Picture 2 u shaped pieces of steel wire and you have the idea. tou probably could make do with something else, but for what the tools cost and their easy availability you might as well spurge for them and throw them in your toolbox whan you're done.

rob
http://http://www.zxtuner.com
1999 ZX2 S/R (stock and back on the road!)
1999 ZX2 S/R (Performance Parts project car) - Ticket magnet
1998 ZX2 Base (MPG project car) - 38.6 mpg  - SOLD
2000 ZX2 A/T (daughters car) - not totalled yet lol